DOC

Measuring Temperature A thermometer measures temperature (maxmin)

By Judy Sanders,2014-05-29 23:14
8 views 0
Measuring Temperature A thermometer measures temperature (maxmin)

    Measuring Temperature: A thermometer measures temperature (max/min). The National Weather Service keeps the thermometer six feet above ground in a white box thus keeping the sensor in the

    shade.

    Measuring Pressure: A barometer measures pressure. *Pressure (P) - the force exerted on a surface divided by the area of the surface

    Properties of Pressure

    o Pressure increases as more gas is added

    ; Conclusion - Pressure (P) is directly proportional to moles of gas (n)

    o Pressure is measured in units that describe force exerted by the gas divided by area

    over which the gas is distributed. 2; e.g. lb/in

    ; Conclusion -

    ; Pressure due to a gas is the same in all directions whereas

    pressure due to weight is directional

     Barometer - apparatus used to measure pressure;

     is derived from the Greek "baros" meaning "weight"

    ; Created by Evangelista Torricelli in 1646

    o Inverted a tube filled with mercury into a dish until the force of the Hg

    inside the tube balanced the force of the atmosphere on the

    surface of the liquid outside the tube

     Example:

Aneroid Barometers: (without liquid)

    The aneroid barometer responds to variation in air

    pressure by the flexing of an evacuated bellows against

    the tension of a powerful spring. The movement of the

    bellows is amplified by a system of levers and converted

    into a rotation by a chain wrapped around a pivoted rod to

    which a pointer is attached. The chain is kept in tension by

    a hairspring, which also takes the slack out of the lever

    joints. Variations in air pressure can give about 200

    degrees of movement of the pointer. Aneroid barometers

    require no special precautions when moved, and many

    were designed as pocket barometers and altimeters for

    surveyors and climbers.

Measuring Winds: An anemometer measures wind speed; A wind vane measures wind direction.

    Measuring Precipitation: A rain gauge measures precipitation. There are two major types of rain gauges used in weather observations. One type is a tipping bucket and the other is a weighing rain

    gauge. Generally, 10" of snow for 1" of rain can work as a fairly good ration but not always. Measuring Humidity: A hygrometer measures humidity.

    Measuring Temperature, Dewpoint, and Humidity (mobile instead of a fixed station):

    A sling psychrometer measures wet bulb and dry bulb from which you can get temperature, dewpoint and relative humidity.

    Definitions of humidity-related terms

    Absolute humidity: The mass of water vapor in a given volume of air( i.e., density of water vapor in a given parcel, usually expressed in grams per cubic meter Specific humidity: The mass of water vapor in a parcel divided by the total mass of the air in the parcel (including water vapor)

    Relative humidity: The amount of water vapor actually in the air divided by the amount of water vapor the air can hold. Relative humidity is expressed as a percentage and can be computed in a variety of ways. One way is to divide the actual vapor pressure by the saturation vapor pressure and then multiply by 100 to convert to a percent. Wet bulb temperature: The lowest temperature that can be obtained by evaporating

    water into the air at constant pressure. The name comes from the technique of putting a wet cloth over the bulb of a mercury thermometer and then blowing air over the cloth until the water evaporates. Since evaporation takes up heat, the thermometer will cool to a lower temperature than a thermometer with a dry bulb at the same time and place. Wet bulb temperatures can be used along with the dry bulb temperature to calculate dew point or relative humidity

     Actual vapor pressure: The partial pressure exerted by the water vapor present in a parcel. Water in a gaseous state (i.e. water vapor) exerts a pressure just like the atmospheric air. Vapor pressure is also measured in millibars.

    Condensation: The phase change of a gas to a liquid. In the atmosphere, the change of water vapor to liquid water.

    Dewpoint: the temperature air would have to be cooled to in order for saturation to occur. The dewpoint temperature assumes there is no change in air pressure or moisture content of the air.

    Dry bulb temperature: The actual air temperature. See wet bulb temperature below.

    Freezing: The phase change of liquid water into ice.

    Evaporation: The phase change of liquid water into water vapor.

    Melting: The phase change of ice into liquid water.

    Mixing ratio: The mass of water vapor in a parcel divided by the mass of the dry air in the parcel (not including

    water vapor)

    Saturation of air: The condition under which the amount of water vapor in the air is the maximum possible at the existing temperature and pressure. Condensation or sublimation will begin if the temperature falls or water vapor is added to the air. Saturation vapor pressure: The maximum partial pressure that water vapor molecules

    would exert if the air were saturated with vapor at a given temperature. Saturation vapor pressure varies with atmospheric pressure. When a given atmospheric pressure is steady, then the saturated vapor pressure is directly proportional to the temperature. Sublimation: In U.S. meteorology, the phase change of water vapor in the air directly into ice or the chance of ice directly into water vapor. Chemists, and sometimes meteorologists, refer to the vapor to solid phase change as "deposition."

Report this document

For any questions or suggestions please email
cust-service@docsford.com