DOC

03.)TPSMHA INSTALL.

By Jill Cox,2014-11-22 07:01
12 views 0
03.)TPSMHA INSTALL.

    Titan Pipe & Supply Co., Inc.

    8213 UP RIVER RD.

    CORPUS CHRISTI, TX 78409

    PH- 1 361 241 7473 / FAX 1 361 241 7471

TPSMHA WATER STOP GASKET

    INSTALLATION

    GUIDE

    Titan Pipe & Supply Co., Inc.

    8213 UP RIVER RD.

    CORPUS CHRISTI, TX 78409

    PH- 1 361 241 7473 / FAX 1 361 241 7471

    TPSMHA WATER STOP GASKET

    INSTALLATION

    GUIDE

    *SPECIAL NOTES*

    Ensure , that at all times, all personnel installing the TPSMHA Water Stop Gasket Assemblies are wearing the Approved & Required PPE as Mandated by OSHA regulations. In the process of cutting Manholes, Wet Wells, Pipe etc. released debris can cause severe Puncture,

    Inhalation, and Eye trauma etc.

    Proper Protective Equipment (PPE) can be identified on the MSDS Sheets that should be provided from the Individuals supplying the

    materials that are being cut.

    Page 1

    Titan Pipe & Supply Co., Inc.

    8213 UP RIVER RD.

    CORPUS CHRISTI, TX 78409

    PH- 1 361 241 7473 / FAX 1 361 241 7471

    TPSMHA WATER STOP GASKET

    INSTALLATION

    GUIDE

    1.) Core the appropriate sized hole in the Manhole / Wet Well etc.

     A. Cut the hole 1/8” larger than the diameter of the pipe being used.

     (Example- 8” SDR-26 HW Sewer PVC has an O.D. of 8.40” add

     the 1/8” to the diameter & the O.D. of the hole would be 8.525”)

2.) Place the TPSMHA Gasket into the hole. Center the TPSMHA Gasket’s

     Middle Channel on to the Manhole / Wet Well

     A. The Inner & Outer Channels are used for Stainless Steel bands

     being placed on the inside and on the outside of the Manhole / Wet

     Well.

    3.) Bevel the pipe being used in the TPSMHA Gasket ?” to 1” back from the

     sooth edge of the pipe.

4.) Lubricate both the outside of the Pipe & the inside of the TPSMHA

     Gasket.

5.) Insert the lubricated pipe into the lubricated gasket. Spin the pipe to the

     left & right while pushing into the TPSMHA Gasket slowly.

    6.) Support the pipe @ the most distant point away from the Manhole / Wet

     Well so the Stainless Steel bands can be installed.

    Page 2

    Titan Pipe & Supply Co., Inc.

    8213 UP RIVER RD.

    CORPUS CHRISTI, TX 78409

    PH- 1 361 241 7473 / FAX 1 361 241 7471

    TPSMHA WATER STOP GASKET

    INSTALLATION

    GUIDE

7.) Install the Stainless Steel bands.

     A. Tighten the Stainless Steel bands enough to prevent them from

     falling off. This is so you can come back to finish any field adjustments

     that may be needed.

8.) Field adjustments as needed.

    9.) Tighten down the Stainless Steel bands to 50 to 60 ft/lbs of torque.

    10.) Install Service Connection as detailed in plans.

    Page 3

Report this document

For any questions or suggestions please email
cust-service@docsford.com