DOC

Teach-in of selection range sensor not possible after EHS replacement -

By Bobby Wallace,2014-10-31 22:23
11 views 0
Teach-in of selection range sensor not possible after EHS replacement -

    Teach-in of selection range sensor not possible after EHS

    replacement -

    主题编号 GI27.60-P-036880

    版本 2

    设计组 27.60 Gearshift, control

    日期 04-08-2007

    有效性 All models with automatic transmission 722.9

    更改原因 Validity revised

投诉

    Teach-in of the selection range sensor not possible after removal/installation of the electrohydraulic controller unit (EHS). During initial startup with Star Diagnosis, the error message "The preconditions are not satisfied or the periphery is nonfunctional" appears although the shift rod was correctly set.

原因

    When installing the EHS, the retaining bolt of the detent plate was not inserted into the plastic bracket of the selector range valve.

    文件 名称

    EHS nicht eingehangt.jpg Bolt not inserted into plastic bracket

补救

    1. Remove/install EHS, inserting the bolt into the bracket on the valve. 2. Repeat teach-in of sensor with Star Diagnosis

症状

    症状

    Power transmission / Automatic transmission / Automatic transmission -

    function / Limp-home mode

    Power transmission / Automatic transmission / Automatic transmission -

    function / General

    Power transmission / Automatic transmission / Automatic transmission operation / Drive position selection / Function / General

    Power transmission / Automatic transmission / Automatic transmission -

    function / No power flow

Power transmission / Automatic transmission / Automatic transmission -

    function / Electrical fault/Fault code

    Power transmission / Automatic transmission / Automatic transmission operation / Drive position selection / Function / Electrical fault/Fault code

Report this document

For any questions or suggestions please email
cust-service@docsford.com