DOC

AutoVue Training Lab Exercises v1

By Jessica Taylor,2014-11-12 20:15
8 views 0
CADBOM Training Lab Exercise v02 Page 1 of 6 AutoVue Training Lab Exercises CADBOM Training Lab Exercise v02 Page 2 of 6 Revision History Version Prepared By Revision Date Revision Description 01 DennisXie 28/12/2006 New Release Approval Approved By Date CADBOM Training Lab Exercise v02 Page 3 of 6 Exercise 1: Part alignments in 3D M..

AutoVue Training Lab

Exercises

CADBOM Training Lab Exercise v02 Page 1 of 6

Revision History

    Version Prepared By Revision Date Revision Description 01 DennisXie 28/12/2006 New Release

Approval

Approved By

    Date

    CADBOM Training Lab Exercise v02 Page 2 of 6

Exercise 1: Part alignments in 3D Models

Objectives

After successfully completing this exercise, you will know how to:

; How to open file.

    ; How to hide parts

    ; How to assemble parts

Step 1. Open file

1. Start AutoVue by IE

    Http://142.120.20.238/jVue/jVue.html (HK)

    Http://142.120.72.164/jVue/jVue.html (CDE)

    Http://142.120.60.248/jVue/jVue.html (EW)

    Http://142.120.51.19/jVue/jVue.html (Cavite)

2. Run menu File->Open local file

    Find and browse \\HTSK-4111\htsk-4111.asm.1

Step 2. Assemble part washer (to-3p.prt.6”)

1. Run Menu Analysis->Part alignment

    2. Check option “Coincident” in Constraint Type

    3. Select part “to-3p.prt.6” (part 4)

    4. Select the face on part 4 which will attatch to part 5 (037-10000488x.prt.6)

    5. Select the attatched face on part 5 6. Check option “Anti-Aligned” in Constraints frame

7. Check “Concentric” in Constraint Type

    8. Select part 4

    9. Select arc on the hole of part 4

    10. Select art on the screw part 1 ( “39120104061.prt.6”)

    11. Press button “Apply”

    12. Press button “Close” to close “part alignment” dialog

Step 3. Assemble spring washer part (“spring-washer-m3.prt.4”)

1. Run Menu Analysis->Part alignment

    2. Check option “Coincident” in Constraint Type

    3. Select part 3

    4. Select the face on part 3 which will attatch to part 4

    CADBOM Training Lab Exercise v02 Page 3 of 6

    5. Select the attatched face on part 4 6. Check option “Anti-Aligned” in Constraints frame

7. Check “Concentric” in Constraint Type

    8. Select part 3

    9. Select arc on the hole of part 3 10. Select art on the screw part 1 11. Press button “Apply”

    12. Press button “Close” to close “part alignment” dialog